Aguato

    Phosphorus and BOD removal from city sewage by an A2O-type process and co-precipitation

    A large public city sewage treatment plant, with a capacity of 900,000 m³/day, receives typical urban sewage from both separate and combined sewers. It is held to a stricter discharge standard than plants in other regions and runs advanced nutrient removal with a phosphorus plant. Its primary clarifiers were also tested at high inflow during rain.

    Treatment line

    1. 01Primary clarifiersCircular gravity settling tanks; the one tested is 3 m deep with a volume of 3,138 m³.
    2. 02A2O-type advanced biological treatmentBiological nutrient removal process of the A2O family.
    3. 03Co-precipitation phosphorus plantChemical co-precipitation to remove total phosphorus.
    4. 04Filtration plant
    5. 05Sodium hypochlorite disinfection

    What the source found

    The plant removed about 98% of BOD and suspended solids and 95% of total phosphorus, its phosphorus removal well above the national average of large plants, while total nitrogen removal was lower at about 67%. During rain the primary clarifiers removed much less, and at twice the design inflow or more with a high sludge blanket the sludge rose and washed out, so inflow control and keeping the sludge blanket at 1 m or less were judged essential.

    Annual average inlet and outlet quality of the whole plant was compared with the national average of large plants, and the primary clarifier inlet and outlet were sampled on five rain events and in test runs at different inflows and sludge blanket heights between March 2012 and June 2013.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    BODBODmg/L150.22.598%
    COD (permanganate)CODMnmg/L92.911.288%
    Suspended solidsTSSmg/L157.5398%
    Total nitrogenTNmg/L36.512.267%
    Total phosphorusTPmg/L3.90.295%

    Inlet: raw sewage at the plant inlet. Outlet: final effluent of the plant. Annual average inlet and outlet quality of the plant. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references