Recycling pulp and board mill wastewater by settling, alum coagulation and activated carbon
A pulp and board mill in Peshawar, Pakistan, produces 6000 m³/day of dark brown wastewater that is poorly biodegradable because of lignin. Combined mill effluent taken from the outlet of the mill's equalisation tank was treated in the laboratory to find a treatment that would let the water be reused in paper production.
Treatment line
- 01Plain settlingFour hours in a glass rectangular tank with a hopper bottom.
- 02Coagulation and flocculationJar tests with alum, lime or magnesium sulfate after adjusting acidity, with fast and slow mixing and 30 minutes of settling; alum worked best.
- 03Granular activated carbon adsorptionTested in beakers with four hours of contact followed by a 10 cm sand bed, and in a down-flow glass column with a detention time of 92 minutes.
What the source found
Settling took out part of the load, and alum worked better than lime or magnesium sulfate in the coagulation step. Activated carbon brought the water to the mill's process water quality so it could be recycled, with 99% of COD and above 99% of suspended solids and colour removed over the whole line. The chemicals make this an expensive option, and a pilot study is needed before it is built.
Eight-hour composite samples taken on eight days, averaged for the raw water, then treated step by step in jar, beaker and column tests; the treated water figures are from the down-flow carbon column test.
Water in, water out
| Parameter | Symbol | Unit | Inlet | Outlet | Removal |
|---|---|---|---|---|---|
| pH | 7.61 | ||||
| BOD | BOD | mg/L | 975 | ||
| COD | COD | mg/L | 2,820 | 22 | 99.2% |
| Total suspended solids | TSS | mg/L | 784 | 4.8 | 99.4% |
| Total dissolved solids | TDS | mg/L | 2,710 | 347 | 87% |
| Total solids | TS | mg/L | 3,494 | ||
| Turbidity | NTU | 645 | 3.2 | 99.5% | |
| Electrical conductivity | EC | µmhos/cm | 1,348 | ||
| Colour | Unit | 6,660 | 25 | 99.6% |
Inlet: raw combined mill effluent. Outlet: outlet of the down-flow activated carbon column. Raw water is the average of eight-hour composite samples taken on eight days; treated water is one down-flow carbon column test after settling and alum coagulation. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.