Colour and COD removal from paper recycling wastewater by electrocoagulation
Wastewater from a paper recycling mill about 10 km from Tehran, Iran, highly coloured and loaded with suspended solids, was sampled and treated in a bench reactor to test electrocoagulation as a treatment method.
Treatment line
- 01Electrocoagulation reactorA stirred batch reactor of 20 by 10 by 17 cm with two iron plates between two aluminium plates, run at its best for 60 minutes at 10 V on the near-neutral raw wastewater with no acid or alkali added.
- 02SettlingTreated samples were left to settle for 30 minutes before analysis.
What the source found
At the best settings the process removed 80% of COD, 83% of suspended solids, over 98% of colour, 85% of ammonia, 35% of dissolved solids and 99% of turbidity. Removal was good from mildly acidic to alkaline conditions and fell in strongly alkaline water, and electrocoagulation was judged a workable option for this wastewater at industrial scale.
Batch tests varying electrolysis time from 10 to 60 minutes, voltage from 4 to 13 V and starting pH, with the raw wastewater characterised and removals measured at each setting.
Water in, water out
| Parameter | Symbol | Unit | Inlet | Outlet | Removal |
|---|---|---|---|---|---|
| Colour | Pt-Co | 8,000 | 99% | ||
| Temperature | °C | 26 to 31 | |||
| pH | 7.2 | ||||
| COD | COD | mg/L | 900 | 80% | |
| Total suspended solids | TSS | mg/L | 4,120 | 83% | |
| Total dissolved solids | TDS | mg/L | 7,000 | 35% | |
| Ammonia | NH3 | mg/L | 4.5 | 85% | |
| Turbidity | NTU | 2,440 | 99.0% |
Inlet: raw paper recycling wastewater. Outlet: settled water after electrocoagulation at the best settings. Raw wastewater characterisation and removals at the best batch test settings. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.