COD and BOD removal from town sewage by primary pond, trickling filter and oxidation ponds
A sewage treatment plant in Eldoret town, Uasin Gishu County, Kenya. Its performance was followed stage by stage in the dry and the wet season.
Treatment line
- 01ScreensRemove solids such as rags and sticks from the raw sewage.
- 02Primary sedimentation pondSolids settle and organic matter is partly broken down without oxygen.
- 03Trickling filtersAerobic filters with microorganisms attached to media, fed by rotating sprinklers.
- 04Sedimentation pondWater from its effluent is pumped back at a flow chamber to mix with the primary pond effluent.
- 05Oxidation ponds (secondary and tertiary ponds)Open ponds where organic matter is further removed, helped by algae.
What the source found
BOD and COD fell at every stage in both seasons. In the dry season the works removed about 87% of COD, 91% of BOD and 70% of suspended solids. Dissolved solids rose after the primary pond in both seasons, and in the wet season suspended solids rose again after the trickling filter. Season did not change overall performance, though most wet season values were lower, which is put down to dilution by rain.
Samples taken at 10 am at the inlet, after the primary pond, after the trickling filter and at the final outlet in February (dry season) and April (wet season) 2019, each analysed in triplicate. The removal figures are from the dry season sampling.
Water in, water out
| Parameter | Symbol | Unit | Inlet | Outlet | Removal |
|---|---|---|---|---|---|
| pH | 7.8 | 8 | |||
| Electrical conductivity | EC | 500 | 1,000 | ||
| Temperature | 22 | 20 | |||
| COD | COD | 1,500 | 200 | 87% | |
| BOD5 | BOD5 | mg/L | 700 | 60 | 91% |
| Total dissolved solids | TDS | mg/L | 400 | 700 | 0% |
| Total suspended solids | TSS | mg/L | 200 | 60 | 70% |
Inlet: raw sewage at the plant inlet. Outlet: final effluent after the oxidation ponds. Samples taken at 10 am in February 2019 (dry season), analysed in triplicate. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair. A parameter at 0% did not fall between the inlet and the outlet.