Aguato

    Polishing UASB-treated sewage for solids and sulfide in a final polishing pond

    A sewage works in Noida, India, with a capacity of 34,000 m³/day treats sewage through screens, grit chambers and upflow anaerobic sludge blanket reactors, then sends the reactor effluent to a final polishing pond. Only the polishing pond is described here. The sewage at this works carries high sulfate, which is put down to industrial wastewater entering the sewers.

    Treatment line

    1. 01Final polishing pond237.4 by 55.1 m and 1.3 m deep, with a design retention time of one day.

    What the source found

    The pond stayed almost without oxygen along its whole length and removed only a small share of BOD and ammonium, while sulfide fell by about two thirds and suspended solids by about 41%. The polishing ponds studied did not meet the BOD and suspended solids disposal standards; their retention time was too short and they were judged to act mainly as clarifiers.

    Grab samples on one day in October 2010 at eight points along the pond, from the inlet to the final effluent.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    Temperature°C28.329.3
    pH7.27.6
    Alkalinity as CaCO3Alkmg/L6806327.1%
    BODBODmg/L846819%
    CODCODmg/L26119226%
    Total suspended solidsTSSmg/L1026041%
    Volatile suspended solidsVSSmg/L563243%
    Ammonium nitrogenNH4-Nmg/L90.57122%
    Nitrate nitrogenNO3-Nmg/L2.53.90%
    Orthophosphate as phosphorusPO4-Pmg/L7.65.725%
    Redox potentialORPmV-344-393
    Dissolved oxygenDOmg/L0.60.14
    SulfideS2−mg/L642266%
    SulfateSO42−mg/L1361750%

    Inlet: inlet of the polishing pond. Outlet: final effluent of the polishing pond. Grab samples on one day in October 2010. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair. A parameter at 0% did not fall between the inlet and the outlet.

    Similar references