Aguato

    COD and BOD removal from mixed industrial wastewater by electro-Fenton pretreatment

    Wastewater from a petrochemical plant, a beet sugar plant and a food plant in industrial zones of New Damietta and Dakahlia was mixed in equal parts to represent the combined drainage of these industries. Its biodegradability was only medium to moderate, so a chemical oxidation pretreatment was tested instead of a biological one.

    Treatment line

    1. 01Electro-Fenton oxidationBeaker test with stainless-steel electrodes at 2 V for 30 minutes, with hydrogen peroxide and ferrous iron added under acidic conditions.

    What the source found

    Electro-Fenton removed 84% of COD, 82% of BOD and 72% of suspended solids, and did better than plain Fenton oxidation. Electro-Fenton also had the lower operating cost. The pretreated water was still above the discharge standards, so further treatment and neutralisation would be needed before discharge.

    Grab samples were mixed into one composite and treated in batch beaker and jar tests, varying acidity, electrodes, time, voltage and reagent doses, with each measurement made in triplicate.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    pH7.115.3
    Total dissolved solidsTDSg/L19.218.63.1%
    Electrical conductivityECms/cm32.6
    Salinityg/L19.318.4
    BODBODmg/L93716782%
    CODCODmg/L1,51223884%
    Oil and greaseO&Gmg/L5,8601,830
    Total phosphorusTPmg/L3.91.9251%
    Total suspended solidsTSSmg/L2,11059872%
    Total Kjeldahl nitrogenTKNmg/L2.340.6771%

    Inlet: composite raw industrial wastewater. Outlet: water after electro-Fenton treatment. One composite of grab samples treated in batch beaker tests at the best conditions, measurements in triplicate. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references