Aguato

    Reuse of membrane bioreactor-treated textile dyeing wastewater by reverse osmosis

    Textile dyeing and finishing wastewater in Zhongshan, Guangdong, China, is already treated in a membrane bioreactor, whose clear, yellowish-brown effluent is still above the national textile reuse standard for salt, colour, iron, manganese and organic matter. Samples of this effluent were used to test six commercial reverse osmosis membranes for producing water that meets that standard; the membrane bioreactor itself was not studied.

    Treatment line

    1. 01Reverse osmosisLaboratory cross-flow rig with flat-sheet polyamide membranes, run in batches at 1 to 4 MPa and 20 to 40 °C while the feed was concentrated.

    What the source found

    All six membranes gave permeate meeting the textile reuse standard even when most of the feed had been recovered as permeate; with one of the six membranes this meant 98% removal of COD, above 99% of iron and 99% of manganese. Flux fell mainly because osmotic pressure rose as the feed was concentrated, and carbonate scale but little organic fouling formed on the membranes. The best balance of permeate quality and flux came at the lowest water recovery tested, 1.0 m/s cross-flow and 20 °C.

    Batch filtration of 2 litre samples of the bioreactor effluent through each membrane, followed by repeat batches, a nine-run orthogonal test of operating conditions and confirmation runs, with permeate sampled at set water recoveries. The removal figures are from the single batch test of one of the six membranes.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    pH8.847.95
    CODCODmg/L71.61.598%
    Total organic carbonTOCmg/L14.30.1999%
    Suspended solidsTSSmg/L00
    Colourdilution times90199%
    IronFemg/L60.01899.7%
    ManganeseMnmg/L0.40.00599%
    Total hardness as CaCO3THmg/L310.83.3599%
    Electrical conductivityECmS/cm5.220.202

    Inlet: bioreactor effluent used as reverse osmosis feed. Outlet: reverse osmosis permeate of one membrane at 70% water recovery. One 2 litre batch filtration test of one membrane, permeate sampled at 70% water recovery. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references