Aguato

    Polishing sewage effluent for irrigation reuse by chlorination and sand filtration

    A municipal sewage plant northwest of Kuwait City, in operation since 1983 with a design capacity of 86,000 m³/day and a present inflow of 65,000 m³/day, treats sewage by screening, grit removal and extended aeration activated sludge with clarifiers, then by a tertiary stage. Most of the effluent goes to a central irrigation water reservoir, part is used for irrigation on site and by tanker, and a small part is sometimes discharged to sea. The tertiary stage described here ends with a final chlorination after the filters.

    Treatment line

    1. 01PrechlorinationChlorine gas is dosed to the clarified effluent to kill algae that would foul the filters.
    2. 02Gravity rapid sand filtersA 60 cm sand layer over 40 cm of supporting gravel at a design rate of 5 m³/m² per hour, with no coagulant added, backwashed daily for 15 minutes with air and water.

    What the source found

    The tertiary stage removed on average about 89% of suspended solids and 66% of BOD, but only 7% of nitrogen and 6% of phosphorus, because the plant has no anoxic tanks and no chemicals are dosed before filtration. Chlorination almost eliminated coliforms, and the final effluent met the national guidelines for restricted irrigation of fodder crops and landscaping.

    Weekly samples of the clarifier effluent and the sand filter effluent over 12 months, from May 2004 to April 2005.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    Total suspended solidsTSSmg/L234.01
    BODBODmg/L25.610.19
    Volatile suspended solidsVSSmg/L17.95383%
    Total nitrogenTNmg/L16.2515.79
    Total phosphorusTPmg/L13.6512.95.5%
    pH7.5
    Coliformcolony/100 mL2.3
    Faecal coliformFCcolony/100 mL1

    Inlet: secondary clarifier effluent before the sand filters. Outlet: sand filter effluent (tertiary effluent). Averages of weekly samples over 12 months from May 2004 to April 2005. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references