Aguato

    Paper mill effluent reuse by pre-filtration, ultrafiltration and reverse osmosis

    Final treated effluent from the secondary clarifier of an agro-residue pulp and paper mill in Uttar Pradesh, India, which makes writing and printing paper, was collected as grab samples and tested on a small membrane rig. The mill's conventional treatment did not give water clean enough to reuse in papermaking, so the test checked whether membranes could bring it to process water quality.

    Treatment line

    1. 01Pre-filtration unitA pre-filter, a sediment filter and a pre-carbon filter in series, there to reduce the load and fouling on the membranes.
    2. 02UltrafiltrationA polyether sulphone membrane with a 30 kDa cut-off, fed by a diaphragm pump.
    3. 03Reverse osmosisAdded after ultrafiltration in the second test set-up.

    What the source found

    Pre-filtration with ultrafiltration removed the suspended solids and most of the colour and lignin, but took out only a small share of COD, BOD and dissolved salts. With reverse osmosis added, the permeate met the water quality tolerances for colour, dissolved solids and suspended solids for all grades of paper.

    Grab samples stored chilled and run through two set-ups, pre-filtration with ultrafiltration and the same with reverse osmosis added, at conditions chosen by a designed experiment, with each analysis done in triplicate.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    Total suspended solidsTSSmg/L560>99.9%
    Total dissolved solidsTDSmg/L2,21526
    CODCODmg/L2160>99.9%
    BODBODmg/L270>99.9%
    ColourPCU4120>99.9%
    Ligninmg/L1260>99.9%
    pH7.465.74
    Electrical conductivityECµs1,36525.1
    PotassiumKmg/L4.20.198%
    SodiumNamg/L283.787%

    Inlet: secondary clarifier effluent. Outlet: permeate after pre-filtration, ultrafiltration and reverse osmosis. Means of triplicate analyses on grab samples run through the bench set-up. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references