Aguato

    COD and sulfate removal from baker's yeast wastewater by anaerobic and anoxic reactors

    The wastewater treatment plant of a baker's yeast factory that runs on beet sugar molasses, treating up to 350 m³/day of process wastewater. The raw water is very strong in organic matter, nitrogen and sulfate and carries brown colouring substances that resist biological treatment. Because the biologically treated water was still highly loaded and brown, post-treatment by coagulation and ozonation was tested in the laboratory.

    Treatment line

    1. 01Mixing tankReceives raw wastewater, wash waters and sludge returned from the secondary settling tank.
    2. 02Two anaerobic reactorsHeld at 30 to 36 °C, with acidity kept steady by the biological process itself, without neutralization.
    3. 03Anoxic reactor
    4. 04Secondary sedimentation tankSettled sludge is returned to the inlet of the mixing tank.

    What the source found

    In 2007 the plant removed about 92% of COD, 86% of suspended solids, 81% of total nitrogen, 60% of total phosphorus and 99% of sulfate, while COD removal ranged from 85% to 92% over six years. The effluent still carried a high organic load and a dark brown colour that biological treatment did not remove. Laboratory tests showed that iron and aluminium coagulants and ozone reduced colour and COD, but both options were judged very expensive.

    Yearly plant inlet and outlet figures for 2003 to 2008; the figures shown are for 2007.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    Total CODCODmg/l32,5872,74492%
    COD (fraction not stated)CODmg/l30,3882,44692%
    Total suspended solidsTSSmg/l2,17431486%
    Total nitrogenTNmg/l2,62549081%
    Total phosphorusTPmg/l502060%
    SulfateSO42−mg/l2,3602099.2%

    Inlet: raw wastewater at the treatment plant inlet. Outlet: treated effluent at the plant outlet. Yearly plant figures; the values shown are for 2007. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references