Aguato

    Nitrogen removal from weak, carbon-poor sewage by step-feed anoxic and aerobic activated sludge

    An underground municipal sewage works in downtown Bangkok, treating on average 84,000 m³ per day and built below ground because of the lack of land, with a recreation and education centre on top. It was designed to remove both organic matter and nitrogen. Its sewers carry rainwater as well as sewage all year, which makes the incoming sewage weak; the sewage has a low ratio of COD to nitrogen, and the works has no primary clarifier.

    Treatment line

    1. 01Step-feed anoxic and aerobic tanksFour feed points to four anoxic and four aerobic tanks, but only two feed points run at a time, in rotation, because of low flow; about 4.1 hours of total retention and a sludge age above 60 days.

    What the source found

    The works removed about 75% of COD, 83% of BOD and 83% of suspended solids, and nitrified well, with about 83% of ammonia removed, but total nitrogen removal was only about 48% and nitrate rose in the effluent. Too little carbon in the weak sewage held back denitrification, even with the long sludge age and low oxygen in the anoxic tanks. A sludge age above 30 days is suggested as a practical answer to carbon-poor sewage.

    Monthly influent and effluent samples over one year in 2018 to 2019, 12 samples in all, together with sludge samples for microbial analysis.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    Temperature°C27.127.4
    pH7.4 to 7.67.2 to 7.4
    Suspended solidsTSSmg/L36683%
    BODBODmg/L35683%
    CODCODmg/L731875%
    AmmoniumNH4+mg/L13.32.383%
    NitrateNO3−mg/L0.45.20%
    NitriteNO2−mg/L0.10.0280%
    Organic nitrogenmg/L4.41.957%
    Total Kjeldahl nitrogenTKNmg/L17.74.276%
    Total nitrogenTNmg/L18.29.448%
    Total phosphorusTPmg/L31.937%

    Inlet: raw sewage entering the works. Outlet: treated effluent of the works. Means of 12 monthly samples over one year in 2018 and 2019. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair. A parameter at 0% did not fall between the inlet and the outlet.

    Similar references