COD and BOD removal from cattle slaughterhouse wastewater by coagulation and electrocoagulation
A cattle slaughterhouse in Zahedan, Sistan and Baluchestan province, has a capacity of 250 cows a day and produces about 60 m³ of wastewater daily, which passes a screen of about 2 mm for coarse solids. The wastewater was treated in the laboratory to see whether it could meet the national limits for direct discharge to surface water.
Treatment line
- 01Preliminary settlingThe wastewater settles for 24 h without chemicals.
- 02Chemical coagulation and flocculationJar tests on 2 L of settled wastewater with polyaluminium chloride, fast and slow mixing, then 30 min of settling. The clear liquid goes on to electrocoagulation.
- 03ElectrocoagulationStirred 2 L batch cell with four aluminium plates in bipolar connection, run for up to 60 min at 10 to 40 V.
What the source found
Settling and coagulation alone lowered the pollution load but could not meet the discharge limits. With electrocoagulation added at the highest voltage and coagulant dose, the whole line removed above 99% of COD and BOD and 97% of suspended solids, and brought COD, BOD and coliforms within the limits. Energy and electrode use rose with voltage.
Raw wastewater and the same after settling were characterised from 48 samples. Each coagulant dose and voltage was tested, with analyses in duplicate and the averages reported.
Water in, water out
| Parameter | Symbol | Unit | Inlet | Outlet | Removal |
|---|---|---|---|---|---|
| pH | 7.31 | ||||
| COD | COD | mg/L | 5,817 | 13 | 99.8% |
| BOD5 | BOD5 | mg/L | 2,543 | 10 | 99.6% |
| Total suspended solids | TSS | mg/L | 3,247 | 82 | 98% |
| Total Kjeldahl nitrogen | TKN | mg/L | 137 | 7 | |
| Fat, oil and grease | FOG | mg/L | 34 | ||
| Electrical conductivity | EC | µS/cm | 9,140 | ||
| Total coliforms | TC | MPN/100 mL | 2.8 × 10^9 | 943 | |
| Faecal coliforms | FC | MPN/100 mL | 1.9 × 10^8 | 72 |
Inlet: raw slaughterhouse wastewater before any treatment. Outlet: filtered sample after coagulation with 100 mg/L polyaluminium chloride and electrocoagulation at 40 V. Raw values are means of 48 samples; treated values are the mean values the source prints for the laboratory runs at the best setting. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.