Suspended solids and phosphorus removal from potato washwater by electrocoagulation
A farm in Quebec washes red potatoes grown on sandy loam. Its washwater passes a coarse filter and a transfer basin and then flows to two non-aerated lagoons in series; the samples were taken at the lagoon inlet and treated in the laboratory. This farm's water was used to find the best operating settings, which were then tried on three other farms.
Treatment line
- 01Batch electrocoagulation cellA 0.5 litre cell with two aluminium plate electrodes 1 cm apart, run for 8.8 minutes at the chosen best setting.
- 02SettlingOne hour of settling, after which the clear upper layer was analysed.
What the source found
At the chosen setting electrocoagulation removed about 99% of suspended solids, 98% of turbidity, 93% of phosphorus and 97% of iron, and suspended solids were below the provincial discharge limit. COD fell by only about 45%. One insecticide fell by 38% while its breakdown product rose, and both stayed above the provincial limit.
Preliminary runs and two statistical test series on lagoon inlet samples set the current and time, then the raw water and the settled treated water at the chosen setting were analysed; values are means with standard deviations.
Water in, water out
| Parameter | Symbol | Unit | Inlet | Outlet | Removal |
|---|---|---|---|---|---|
| pH | 7.2 | 6.5 | |||
| Turbidity | NTU | 246 | 3.8 | 99% | |
| Total suspended solids | TSS | mg/L | 215 | 1.6 | 99.3% |
| COD | COD | mg/L | 145 | 80 | 45% |
| Total phosphorus | TP | mg/L | 1.4 | 0.1 | 93% |
| Aluminium (Al3+) | Al3+ | mg/L | 13.2 | 0.06 | 99.5% |
| Iron (Fe3+) | Fe3+ | mg/L | 2.2 | 0.06 | 97% |
| Thiamethoxam | µg/L | 0.71 | 0.44 | 38% | |
| Clothianidin | µg/L | 0.25 | 0.76 |
Inlet: red potato washwater taken at the lagoon inlet. Outlet: clear upper layer after electrocoagulation and one hour of settling. Laboratory batch electrocoagulation at 0.32 A for 8.8 minutes; means with standard deviations. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.