COD and chromium removal from tannery wastewater by nanofiltration and reverse osmosis
Tannery wastewater that has already passed coarse screening, sand settling, oil skimming, sulphide oxidation, flocculation and flotation is still not fit for discharge to surface water and is normally sent to an external biological treatment service. Two membrane stages in series were tested as a replacement for that biological step, so that most of the water could be discharged and a chromium-rich concentrate returned to the tannery.
Treatment line
- 01NanofiltrationSpiral-wound module of 0.51 m² in a batch pilot with a 100 litre feed tank, run at 6 bar, the pressure found to limit fouling.
- 02Reverse osmosisSpiral-wound module of 0.51 m² fed with the nanofiltration permeate and run at 22 bar; it showed no significant fouling.
What the source found
Nanofiltration alone brought most parameters within the surface water discharge limits but not chromium, so reverse osmosis was added and its permeate met the limits for COD, suspended solids and chromium. Across both stages the line removed 95% of COD and all suspended solids. A full-size membrane plant was estimated to cost less than the external biological treatment service, with most of the water discharged and a small chromium-rich concentrate returned to the tannery.
Batch pilot runs at 20 °C on the pretreated wastewater, with pressure cycling to find the fouling threshold and analysis of the feed, the nanofiltration permeate and the reverse osmosis permeate.
Water in, water out
| Parameter | Symbol | Unit | Inlet | Outlet | Removal |
|---|---|---|---|---|---|
| COD | COD | mg/L | 2,020 | 86 | 96% |
| Total suspended solids | TSS | mg/L | 266 | 0 | >99.9% |
| Ammonium | NH4+ | mg/L | 69 | ||
| Phosphate | PO43− | mg/L | 2.5 | ||
| Sulfide | S2− | mg/L | 0.09 | ||
| Chromium | Cr | mg/L | 195 | 0.04 | >99.9% |
Inlet: pretreated tannery wastewater fed to the membrane pilot. Outlet: reverse osmosis permeate after nanofiltration and reverse osmosis in series. Analyses of the feed and of the reverse osmosis permeate from batch pilot runs at 20 °C. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.