Aguato

    Neutralising steel pickling wastewater and removing metals with lime-rich paper mill waste

    Acidic wastewater from steel pickling at two steelmaking plants must be neutralised before disposal or reuse, which is usually done with primary lime. Four batches of this real wastewater were treated in the laboratory with calcium oxide rich wastes from pulp and paper mills, fly ash and calcined lime mud, to see whether they could replace primary lime.

    Treatment line

    1. 01Neutralisation and hydroxide precipitationCalcined lime mud, fly ash or primary lime powder added to a stirred 210 millilitre beaker and mixed at about 500 rpm for up to 30 minutes so the dissolved metals precipitate as hydroxides.

    What the source found

    Calcined lime mud neutralised the water as well as primary lime and needed 2.2 to 2.7 times less material than fly ash, thanks to its higher calcium oxide content and finer particles. Chromium, iron, nickel and molybdenum fell sharply in all trials, with lime mud cleaning the water about as well as primary lime and fly ash less well. Calcining the fly ash and primary lime beforehand cut the amount needed.

    In total 88 beaker trials on four wastewater batches; metals were measured before and after neutralisation in two of the batches, and the figures are from one trial with calcined lime mud.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    pH9.1
    ChromiumCrmg/L6180.1>99.9%
    IronFemg/L2,3500.54>99.9%
    NickelNimg/L1,0841.6799.8%
    ZincZnmg/L1.50.0199.3%
    MolybdenumMomg/L1171.0699.1%

    Inlet: acidic pickling wastewater as received. Outlet: wastewater after neutralisation with calcined lime mud. One laboratory beaker trial with 19 g/L of calcined lime mud on one wastewater batch. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references