Aguato

    Turbidity and BOD removal from fish processing wastewater by shrimp-shell chitosan coagulation

    Wastewater from a fish processing plant in the industrial area of Anza, Agadir, Morocco, exceeded the national discharge limits on every measured indicator except pH. Samples were taken to the laboratory to test a liquid chitosan coagulant made from local shrimp shells, a waste of the same industry, as a natural alternative to chemical coagulants.

    Treatment line

    1. 01Coagulation with liquid chitosanJar tests on 0.5 litre samples with rapid mixing for 5 minutes and slow mixing for 20 minutes, working best in alkaline conditions at around 20 °C, with no flocculant added.
    2. 02Settling30 minutes of settling, after which the clear water was drawn off for analysis.

    What the source found

    At the best conditions the shrimp-shell coagulant removed about 98% of turbidity and 53% of BOD, forming large flocs that settled in 30 minutes and visibly decolouring the water. It performed about as well as commercial chitosan and better than ferric chloride on BOD, but the treated water from all three coagulants still exceeded the national direct discharge limit for BOD.

    Jar tests varying coagulant dose and pH, then a designed experiment over dose, temperature and pH, with the best conditions confirmed in more than three repeat runs.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    Temperature°C18.5
    pH7.06
    Electrical conductivityECµS/cm15,500
    Turbidity92598%
    BOD5BOD5mg O2/L2,345.553%

    Inlet: raw fish processing wastewater. Outlet: clarified water after coagulation and settling. Inlet values are the means of the raw wastewater characterization; removals are from repeated confirmation jar tests at the optimum conditions, with no treated values printed. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references