Aguato

    Copper and zinc removal from acid mine drainage by limestone neutralization

    Acid drainage from an open ditch at a large open-pit copper mine in Dexing, Jiangxi Province, mined since 1958, is strongly acidic and rich in iron, copper, zinc and sulfate. Samples were neutralized with limestone in the laboratory to see how the iron minerals that form take up copper and zinc and whether they hold them over time.

    Treatment line

    1. 01Limestone neutralization in shaken flasksDrainage mixed with reagent limestone at a lower and a higher dose in film-covered flasks, shaken 8 hours a day at 25 °C and kept for up to 300 days; iron precipitates as oxyhydroxides that carry copper and zinc into the sediment.

    What the source found

    Both doses removed 99% or more of the iron within 6 hours and about 99% of the copper within one day; zinc removal was above 99% at the higher dose but fell back to about 90% by day 300 at the lower dose, while the liquid at that dose became acidic again. Copper and zinc were held mainly by the iron oxyhydroxides, and the risk of the metals being released again from the sediment changed with time and dose.

    Triplicate flask tests at two limestone doses, with the liquid sampled from 2 hours up to 300 days and the sediments analysed for mineral form and metal binding. The zinc figure is for the higher dose.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    pH2.696.97
    IronFemg/L475.66
    CopperCumg/L85.8899.0%
    ZincZnmg/L3.78
    CadmiumCdmg/L0.027
    SulfateSO42−mg/L13,070.41

    Inlet: raw acid mine drainage. Outlet: supernatant of the flasks dosed with the higher limestone dose. Inlet values are the characterization of the drainage used; removals are from the triplicate flask tests stated in the results text (iron after 6 hours, copper after 1 day), with no treated concentrations printed; the outlet pH is the value it settled at with the higher dose after the first 30 days. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references