Aguato

    Fat and COD removal from abattoir wastewater by enzyme pre-treatment, anaerobic reactor and MBR

    Wastewater from a poultry abattoir in the Western Cape, rich in fats, oil and grease, was treated in a laboratory-scale plant. The aim was to break down the fats before anaerobic treatment so that they would not clog the anaerobic bed or the membranes.

    Treatment line

    1. 01Aerated biological pre-treatment tank20 L tank dosed with a commercial mix of bacteria, fungi and enzymes, aerated for 24 h and then settled for 24 h, with the floating fat collected from the top.
    2. 02Sieve75 micrometre sieve on the pre-treated water before the stirred feed tank.
    3. 03Down-flow expanded granular bed reactor2 L anaerobic reactor seeded with granules, kept at mesophilic temperature with a water jacket, with a hydraulic retention time of about 5.7 h.
    4. 04Membrane bioreactorAerated 100 L tank with submerged polyethersulfone membranes of 0.04 micrometre pores, polishing the anaerobic effluent.

    What the source found

    The pre-treatment removed most of the fats before the anaerobic reactor, which then ran without clogging or backwashing. Across the whole line, COD, suspended solids and fats were each cut by 99%. Foam built up in the membrane unit during aeration, and the unit was stopped after five weeks because of a build-up of biological slime.

    Samples were taken every second day after pre-treatment, at the inlet and outlet of the anaerobic reactor, and weekly after the membrane unit, with outliers replaced by the median.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    CODCODmg/L6500 to 2100099.0%
    Total suspended solidsTSSmg/L2985 to 836399.0%
    Fats, oil and greaseFOGmg/L640 to 450099.0%

    Inlet: raw poultry abattoir wastewater. Outlet: membrane bioreactor permeate. Ranges of the raw wastewater over the study; no outlet concentrations are printed, only overall removals. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references