BOD and COD removal from starch processing wastewater by extended-aeration activated sludge
The wastewater treatment station of a starch processing factory in Pernambuco state. It is one of six activated sludge plants in the state that were sampled to relate treatment results to the microorganisms in the sludge. The inlet sample was strongly alkaline.
Treatment line
- 01Grit chamberInlet samples were taken where the wastewater enters it.
- 02Extended-aeration activated sludge tankSludge samples were taken here to identify the microorganisms.
- 03Secondary clarifierOutlet samples were taken at its exit.
What the source found
The plant removed about 91% of COD, 99% of BOD, 92% of colour and 87% of turbidity, and the pH, ammonia and BOD removal met the national discharge rule. Suspended solids fell by only 18%, total solids and salt were higher at the outlet than at the inlet, and nitrate rose, which may point to nitrification. The sludge volume index was very high, a sign of possible bulking.
One sample at the inlet and one at the outlet, taken at the same moment in February 2016, in the dry season.
Water in, water out
| Parameter | Symbol | Unit | Inlet | Outlet | Removal |
|---|---|---|---|---|---|
| COD | COD | mg O2/L | 847 | 74 | 91% |
| BOD5 | BOD5 | mg O2/L | 600 | 7 | 99% |
| Total solids | TS | mg/L | 1,140 | 1,650 | 0% |
| Fixed solids | FS | mg/L | 890 | 1,440 | 0% |
| Volatile solids | VS | mg/L | 250 | 210 | 16% |
| Total suspended solids | TSS | mg/L | 110 | 90 | 18% |
| Fixed suspended solids | FSS | mg/L | 80 | 60 | 25% |
| Volatile suspended solids | VSS | mg/L | 30 | 30 | 0% |
| Ammonia nitrogen | NH3-N | mg/L | 2.2 | 0.04 | 98% |
| Nitrate nitrogen | NO3-N | mg/L | 46 | 59.8 | 0% |
| Electrical conductivity | EC | µS/cm | 2.45 | 3.32 | |
| Colour | mg Pt-Co/L | 920 | 71 | 92% | |
| pH | 11.3 | 7.3 | |||
| Turbidity | NTU | 60.1 | 7.82 | 87% | |
| Sodium chloride | NaCl | mg/L | 1,156 | 1,612 | 0% |
| Electrical resistance | Ω | 444.6 | 328.1 |
Inlet: grit chamber inlet. Outlet: secondary clarifier outlet. One inlet sample at the grit chamber and one outlet sample after the secondary clarifier, taken at the same moment in February 2016, in the dry season. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair. A parameter at 0% did not fall between the inlet and the outlet.