COD and phosphorus removal from dairy microfiltration retentate by activated sludge
The wastewater came from a dairy plant in the Mazowieckie Province of Poland and was a mix of production wastewater and water from cleaning a production line with lye and hypochlorite. A 100 L batch was first concentrated to half its volume by microfiltration, and the concentrated retentate was then treated with activated sludge from the plant; the treated water was afterwards passed through powdered activated carbon in a separate step. The figures here cover only the activated sludge step.
Treatment line
- 01Sequencing batch reactor with activated sludge50 L stirred bioreactor run as one 23.5-hour cycle: filling, 21 hours of aerobic reaction, settling and decanting.
What the source found
One cycle of activated sludge treatment cut COD by 62%, total nitrogen by 34% and phosphorus by 47%, with most of the removal in the first 14.5 hours. Nitrogen and phosphorus removal levelled off, probably because mixing alone gave too little oxygen. Even after the following activated carbon step the treated water did not meet the national discharge requirements.
Triplicate grab samples of the concentrated retentate fed to the reactor and of the decanted water after one treatment cycle, plus samples at each phase of the cycle.
Water in, water out
| Parameter | Symbol | Unit | Inlet | Outlet | Removal |
|---|---|---|---|---|---|
| pH | 6.96 | 7.3 | |||
| Electrical conductivity | EC | µS/cm | 1,602.8 | 1,561.27 | |
| Turbidity | NTU | 1,259 | 311.6 | 75% | |
| COD | COD | mg/dm3 | 3,454 | 1,319.67 | 62% |
| Total bound nitrogen | mg/dm3 | 86 | 56.5 | 34% | |
| Total phosphorus | TP | mg/dm3 | 9.4 | 47% | |
| Total organic carbon | TOC | mg/dm3 | 648.07 | 456.65 | 30% |
Inlet: concentrated microfiltration retentate fed to the reactor. Outlet: decanted water at the end of the reactor cycle. Means of triplicate samples over one 23.5 hour treatment cycle. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.