Aguato

    COD removal and biogas from brewery wastewater by an upflow anaerobic sludge blanket reactor

    A brewery in Kombolcha, northern Ethiopia, treats an average of 840 m³ of wastewater a day in an anaerobic plant that produces methane. The anaerobic effluent still exceeded national discharge limits for organics, suspended solids and nutrients, so a pilot two-stage planted horizontal subsurface flow wetland was built on site to polish part of it.

    Treatment line

    1. 01ScreensHold back heavy solids, oil and grease.
    2. 02Buffer tankEvens out swings in flow and acidity from brewing; hydrochloric acid and sodium hydroxide are used in this pre-treatment to correct acidity.
    3. 03Upflow anaerobic sludge blanket reactor592 m³ with an 11 hour retention time, producing methane-rich biogas.

    What the source found

    Over the year the anaerobic plant removed 79% of COD and 59% of suspended solids, but removed little nitrogen and phosphorus, and its effluent did not meet national discharge limits. In the pilot, two planted wetland cells in series brought the anaerobic effluent within those limits for all measured parameters except phosphorus.

    Samples three times a month at the inlet and outlet of the anaerobic plant over one year.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    Total suspended solidsTSS59%
    CODCOD79%
    Total nitrogenTN34%
    Total phosphorusTP32%
    OrthophosphatePO43−39%
    Temperature°C3432.7
    pH7.27.6
    Dissolved oxygenDOmgL-10.4

    Inlet: brewery wastewater entering the anaerobic reactor. Outlet: anaerobic reactor effluent. Annual figures from samples taken three times a month for one year; the source prints the removals and annual means only for the rows below. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references