Suspended solids and turbidity removal from catfish pond effluent by plant-seed coagulation
Effluent was drawn from the outlet of a catfish pond system in Agu-Awka, Nigeria, that raises fish for home use and sale. The green water carried organic matter and suspended solids, and an extract of plant seeds was tested as a natural coagulant in place of chemical ones.
Treatment line
- 01Acidity adjustmentHydrochloric acid or sodium hydroxide was added to set the acidity before dosing.
- 02Seed-extract coagulation and flocculationSeed extract dosed into 1 litre beakers, stirred fast for 5 minutes and then slowly for 20 minutes.
- 03SettlingFlocs left to settle for up to 60 minutes, with samples drawn below the surface.
What the source found
At the best dose, under acidic conditions and at 30 °C, the seed extract removed 89% of suspended solids, 82% of COD and 82% of BOD, and turbidity fell by 90%. The treatment made the water more biodegradable, but the best acidity lay outside the discharge range, so its correction and scale-up still need study.
Jar tests in 1 litre beakers varying coagulant dose, acidity, temperature and settling time, with the effect of each factor checked by analysis of variance.
Water in, water out
| Parameter | Symbol | Unit | Inlet | Outlet | Removal |
|---|---|---|---|---|---|
| Absorbance at 275 nm | 0.842 | ||||
| Ammoniacal nitrogen | NH3-N | mg/L | 0.829 | ||
| BOD5 | BOD5 | mg/L | 317 | 82% | |
| Calcium | Ca | mg/L | 5.4 | ||
| COD | COD | mg/L | 758 | 82% | |
| Chloride | Cl− | mg/L | 2.44 | ||
| Electrical conductivity | EC | µS/cm | 1,963 | ||
| Iron | Fe | mg/L | 0.425 | ||
| pH | 7.9 | ||||
| Potassium | K | mg/L | 5.45 | ||
| Temperature | K | 303.2 | |||
| Total dissolved solids | TDS | mg/L | 650 | ||
| Total phosphorus | TP | mg/L | 0.91 | ||
| Total solids | TS | mg/L | 695 | ||
| Total suspended solids | TSS | mg/L | 45 | 89% | |
| Turbidity | NTU | 404 | 90% | ||
| Colour | 66% |
Inlet: fish pond effluent before treatment. Outlet: settled water after seed-extract coagulation. Inlet values are one characterization of the effluent used; removals are the best jar test results at the optimum dose, pH and temperature, with no treated values printed. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.