Aguato

    Ammonia removal from petrochemical wastewater by adsorption on leaf-based activated carbon

    Ammonia-bearing wastewater from a petrochemical company in Asaluyeh, Iran, sampled at two points of the site. It was treated in batch tests with a low-cost activated carbon made by carbonising tree leaves; a biochar made from brown seaweed was tested alongside it.

    Treatment line

    1. 01Batch adsorption on leaf-based activated carbonThe carbon was stirred into the wastewater at 25 °C without changing its acidity, then filtered off.

    What the source found

    The activated carbon removed 89% of the ammonium but only 2% of the COD and 4% of the BOD. The treated water still did not meet the national ammonia standard for discharge to water bodies, so further treatment would be needed.

    Two wastewater samples were treated in the laboratory, and ammonium, COD, BOD and conductivity were measured before and after. The figures are from the sample labelled raw sewage.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    AmmoniumNH4+mg/L3003389%
    BOD5BOD5mg/L2842733.9%
    CODCODmg/L5655541.9%
    pH8.98.5
    Electrical conductivityECµS/cm1,6001,510

    Inlet: raw wastewater sample. Outlet: the same sample after treatment with leaf-based activated carbon. One wastewater sample treated in a laboratory batch test at 25 °C with 5 g/L of adsorbent. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references