Aguato

    Ammonium and sulfate removal from acidic fertiliser factory wastewater by reverse osmosis

    The wastewater comes from a partially disused fertiliser production site in Italy and is strongly acidic and loaded mainly with inorganic salts, phosphate, ammonium and fluoride. The site already treats about 200 m³/day by liming first and reverse osmosis last; this work tested a seawater reverse osmosis membrane on the real wastewater in the laboratory, as a comparison for vacuum membrane distillation.

    Treatment line

    1. 01Reverse osmosis flat-sheet test cellPolyamide thin-film seawater membrane of 66 cm² fed at 25 °C and run at 20, 30 and 40 bar, with permeate and concentrate recycled to the feed tank.

    What the source found

    Permeate quality improved as pressure rose; at 40 bar sulfate retention was above 99%, ammonium and chloride 98%, COD 87% and fluoride 86%. Fluoride stayed above the surface discharge limit and the permeate remained too acidic. The low fluoride retention was put down to the acidity of the feed. The membrane fouled more than the membrane distillation membranes, and water rinsing recovered only part of its original flux.

    One-hour laboratory runs at each of three pressures on the real wastewater, with the permeate analysed at the end of each run and pure water flux measured before and after. The figures are from the run at 40 bar.

    Water in, water out

    ParameterSymbolUnitInletOutletRemoval
    Electrical conductivityECµS/cm11,9601,050
    pH33.2
    ChlorideCl−mg/L1,98644.698%
    FluorideF−mg/L16123.286%
    PhosphatePO43−mg/L3,12113.199.6%
    SulfateSO42−mg/L2,2906.199.7%
    Ammonium as the ionNH4+mg/L2966.498%
    CODCODmg/L1191587%

    Inlet: raw acidic wastewater fed to the test cell. Outlet: reverse osmosis permeate. Average permeate of one one-hour laboratory run at 40 bar against the wastewater characterisation. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.

    Similar references