COD and BOD removal from personal-care products wastewater by extended aeration
The wastewater treatment station of a factory making personal hygiene products in the state of Pernambuco, Brazil. It is one of six extended-aeration activated sludge stations in the state that were sampled to relate treatment performance to the microorganisms in the sludge.
Treatment line
- 01Grit chamberInlet samples were taken at its entrance.
- 02Extended-aeration activated sludge tankSludge samples were taken here to identify the microorganisms present.
- 03Secondary clarifierOutlet samples were taken at its exit.
What the source found
In the second sampling the station removed 85% of the COD, 83% of the BOD, 69% of the suspended solids and colour, and 77% of the turbidity, and its BOD removal and ammonia met the national effluent standard. The outlet still carried a high organic load, and the most common sludge organisms pointed to under-aeration and a high organic load. Nitrate did not fall: it rose across the plant.
Two dry-season samplings in 2015, in August and October, each with one inlet sample at the grit chamber and one outlet sample after the secondary clarifier. The figures are from the October sampling.
Water in, water out
| Parameter | Symbol | Unit | Inlet | Outlet | Removal |
|---|---|---|---|---|---|
| COD | COD | mg O2/L | 1,402 | 207 | 85% |
| BOD5 | BOD5 | mg O2/L | 950 | 160 | 83% |
| Total solids | TS | mg/L | 965 | 427 | 56% |
| Fixed solids | FS | mg/L | 466 | 259 | 44% |
| Volatile solids | VS | mg/L | 499 | 168 | 66% |
| Total suspended solids | TSS | mg/L | 346 | 106 | 69% |
| Fixed suspended solids | FSS | mg/L | 74 | 12 | 84% |
| Volatile suspended solids | VSS | mg/L | 272 | 94 | 65% |
| Ammonia nitrogen | NH3-N | mg/L | 0.76 | 0.95 | 0% |
| Nitrate nitrogen | NO3-N | mg/L | 3.6 | 5.9 | 0% |
| Electrical conductivity | EC | µS/cm | 1,294 | 810.6 | |
| Colour | mg Pt-Co/L | 577 | 179 | 69% | |
| pH | 8.1 | 8.2 | |||
| Turbidity | NTU | 302 | 68.3 | 77% |
Inlet: grit chamber inlet. Outlet: secondary clarifier outlet. One inlet sample at the grit chamber and one outlet sample after the secondary clarifier, taken at the same moment in October 2015, in the dry season. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair. A parameter at 0% did not fall between the inlet and the outlet.