TMAH and dissolved solids removal from semiconductor wastewater by reverse osmosis
Mixed wastewater from a semiconductor manufacturer in South Korea, which combines four production wastewater lines before its own treatment, was collected on a single day and tested in the laboratory. The wastewater contains tetramethylammonium hydroxide (TMAH), a toxic etching and photolithography chemical that must be removed before discharge. Reverse osmosis was compared with nanofiltration and membrane capacitive deionization on the same water.
Treatment line
- 01Reverse osmosis (stirred cell)Polyamide thin-film composite membrane on a 200 mL batch of wastewater at 20 °C, run to a high recovery.
What the source found
Reverse osmosis removed 88% of dissolved solids and 92% of TMAH but only 56% of organic carbon. Nanofiltration was not adequate for TMAH, while membrane capacitive deionization matched reverse osmosis on TMAH and removed more organic carbon. Membrane fouling and energy use are drawbacks of reverse osmosis on this industrial feed.
Bench stirred-cell runs, each repeated at least three times, with the permeate analysed for dissolved solids, organic carbon and TMAH.
Water in, water out
| Parameter | Symbol | Unit | Inlet | Outlet | Removal |
|---|---|---|---|---|---|
| Tetramethylammonium hydroxide (TMAH) | mg/L | 39.8 | 3 | 93% | |
| Total organic carbon | TOC | mg/L | 12.7 | 5.6 | 56% |
| Total dissolved solids | TDS | mg/L | 181 | 23.9 | 87% |
| Sodium | Na | mg/L | 44.1 | ||
| Calcium | Ca | mg/L | 13.4 | ||
| Chloride | Cl− | mg/L | 26.3 | ||
| Sulfate | SO42− | mg/L | 23.2 |
Inlet: mixed semiconductor wastewater fed to the stirred cell. Outlet: reverse osmosis permeate. Bench stirred-cell runs on one batch of wastewater collected on a single day, each repeated at least three times. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.