Drinking water from seawater wells by sand and cartridge filtration and reverse osmosis
A small seawater reverse osmosis plant on a university campus in Chabahar, on Iran's Oman Sea coast, produces 336 m³ of fresh water a day in an arid region with little fresh water. Its feed comes from two deep wells about 400 m from the beach, so the seawater arrives with fewer suspended solids.
Treatment line
- 01Well intakeA low-pressure pump draws saline water from two wells at about 6 bar.
- 02Relaxation poolsFirst of three pretreatment steps that remove suspended particles.
- 03Sand tanksRemove suspended particles.
- 04Cartridge filterFinal removal of suspended particles before the membranes.
- 05Chemical dosing mixerAdds chemicals that protect the membrane elements.
- 06High-pressure pumpRaises the feed to 45 bar; there is no energy recovery device and no feed bypass.
- 07Reverse osmosis120 spiral-wound seawater elements of 37 m² each in two trains of five pressure vessels, run at a recovery of 0.4, with brine leaving at 43 bar.
What the source found
The product water quality fluctuated but stayed within the national drinking water standard. The cost model showed that only part of the installed membrane area is used at the current feed flow, and that a larger feed flow and a higher recovery would cut the cost of water considerably; the limited well supply should be addressed by drilling new wells.
The product water was sampled 78 times over one month under normal operation, and average feed, product and brine quality was measured. A cost model of the plant was built from the operating data.
Water in, water out
| Parameter | Symbol | Unit | Inlet | Outlet | Removal |
|---|---|---|---|---|---|
| Total dissolved solids | TDS | mg/L | 31,400 | 400 | 99% |
| Chloride | Cl− | mg/L | 26,000 | 280 | |
| Sodium | Na | mg/L | 13,000 | 198 | |
| Potassium | K | mg/L | 648 | 28 | 96% |
| pH | 7.4 | 7.5 | |||
| Turbidity | NTU | 3 | 1 | 67% | |
| Hardness | TH | mg/L | 833.3 | 50 | 94% |
Inlet: feed water of the reverse osmosis plant. Outlet: product water of the reverse osmosis plant. Averages printed by the source for feed and product water; the product water was sampled 78 times over one month of normal operation. Values and units are as the published source prints them. Removal is worked out from the two values, or is the source's own figure where it prints no pair.